Filter
Top Products
Connecting the DDI-1 to the Computer
1. Check that the computer and disc drive(s) are switched off.
2. Plug the Interface Unit firmly into the edge-connector marked FLOPPY DISC at
the rear of the computer (See Figure 1)
Figure 1
3. At the end of the ribbon cable from the Interface Unit, you will find a plug which is
to be used for connecting to the main disc drive (Drive A), see Figure 2.
The plug which you will find slightly further back in the cable (see Figure 2) is to
be used only for connecting to a second disc drive (Drive B); i.e. if you have
purchased an additional Amstrad FD-1.
Figure 2
AMSTRAD Disc Drive & Interface DDI-1 Manual Foundation 1.2
Rear of Computer
Interface Unit
Interface
Unit
Ribbon
Cable
Connector Plug to
Main Disc Drive
(Drive A)
Connector Plug to
Second Disc Drive
(Drive B)