Filter
Top Products
Media Settings
34
Adjusting Print Position
The Operator Panel menu includes a feature for adjusting the print position in
the X (label width) and Y (along the feed direction) directions. Use the
following procedure when the label requires a minor adjustment (+ or - 1.0
inch) to improve the position of the printed image.
1. Press the
ONLINE
PAUSE
key. This takes you to the off-line menu.
2. When Interface Status Off-Line is displayed, press the
MENU
key. This
will take you the to the listing of sub-menus.
3. Press the
MENU
key until the Label Parameters option is displayed.
4. Press the
ITEM
FEED
key until the X Offset parameter is displayed. Use the
or
CANCEL
keys to set the X offset value.
5. Press the
ITEM
FEED
key again. The Y Offset parameter is displayed.
Use the or
CANCEL
keys to set the Y offset value.
6. Press the
ONLINE
PAUSE
key. If any parameters were changed, the display will read
ENTER to save new defaults. Press the
ENTER
PRINT
key to save these values.