Filter
Top Products
Automatic Transfer Switch—Installation and Quick Start10
Control console
After you log on at the control console, as described in “Local access to the control console” on page 8 or
“Remote access to the control console” on page 9:
1. Choose Network from the Control Console menu.
2. Choose
TCP/IP from the Network menu.
3. If you are not using a
BOOTP or DHCP server to configure the TCP/IP settings, select the Boot
Mode menu. Select Manual boot mode, and then press ESC to return to the TCP/IP menu.
(Changes will take effect when you log out).
4. Set the System
IP, Subnet Mask, and Default Gateway address values.
5. Press
CTRL+C to exit to the Control Console menu.
6. Log out (option 4 in the Control Console menu).
Note: If you disconnected a cable during the procedure described in “Local access to
the control console” on page 8, reconnect that cable and restart the associated service.