Filter
Top Products
iMac (17-inch Mid 2006/Late 2006 CD) Take Apart — Display Panel 55
Replace the right panel mounting bracket on the display panel with two screws.
Replace the left bracket on the display panel with two screws.
Connect the two inverter-to-display cable connectors and tape them to the back of the
display panel. Tape the middle inverter cable to the back of the display as well.
Turn over the panel. If the lower EMI shield was removed, reattach the lower EMI shield
across the bottom of the panel.
Position the panel into the rear housing. Make sure the inverter cable and the LVDS cable are
accessible and not tucked under the panel.
Secure the panel with four T10 mounting screws.
Connect the inverter cable connector to the logic board.
Connect the LVDS cable connector to the logic board and secure it with two T6 screws.
Fold the EMI tape rmly over the left, top, and right edges of the display panel. Use the black
stick to adhere the tape rmly and rub out wrinkles.
Replace the lower EMI shield.
Replace the front bezel.
Replace the access door.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
922-7158
922-7023
922-7010