Filter
Top Products
E-12
■ Buttons and Indicator Lights
OHP
SCROLL
ON/
STANDBY
LAMP/
COVER
TEMP
BRIGHTNESS
ZOOM
POWER
MENUMUTEKEYSTONE
PC1/PC2 VIDEO
o !0
!1
werq
yu i
t
Name
q POWER Button
w TEMP LED
e LAMP/COVER LED
r ON/STANDBY LED
t INPUT SELECT Buttons
(OHP, PC1/PC2, VIDEO)
y KEYSTONE Button
u MUTE Button
i BRIGHTNESS Buttons
Description
• Press this button to turn the lamp on or off.
• Only this button can be used when the lamp is off.
• This LED blinks for ten seconds and lights when the
temperature inside the projector has built up.
• This LED lights while the lamp is on.
• When the lamp is turned on, it blinks for about six seconds
then remains on.
• When the lamp is off, it blinks for about 60 seconds then
remains off.
• This LED blinks when the lamp fails to light. (The LED
blinking pattern in this case is longer than other instances.)
• Blinks when the lamp usage time exceeds 1400 hours, it
remains on after lamp usage time exceeds 1500 hours.
• Lights when the air filter cover or the lamp unit cover is not
in place.
• This LED lights (red) in a standby state, and lights (green)
when the lamp is on.
• Press this button to switch the input screen.
• When PC is selected, images from the PC input terminal
are projected; when VIDEO is selected, images from the
video source input terminal are projected; or, when OHP is
selected, an image of the printed matter or document
placed on the scanner on the main unit is projected.
Pressing on the PC1/PC2 button when PC input is selected
switches between PC input 1 and PC input 2.
• Press this button to compensate keystone.
• Press to stop projecting the image without turning off the
lamp. Press it again and the image will reappear.
• These buttons adjust the brightness. Pressing the
BRIGHTNESS
button darkens the projected image, and pressing the
BRIGHTNESS
button lightens the projected image.
Page to see
E-20, 29,
41
E-52
E-29
E-41
E-54
E-54, 56
E-29, 41
E-29
E-21
E-34, 40
E-31, 37