Filter
Top Products
QLS-4100 X 93
8
9
10
11
Reconnect the three harness connectors to the replacement printhead.
Position the printhead under the bracket and move the printhead around until it
seats into the two locating pins in the bracket.
Tighten the captive mounting screw 1/4 turn to secure the printhead to the bracket.
Reinstall the platen roller on print station #1 if it was removed.
Warning
Do not over tighten the captive mounting screw. Damage or warpage to
the printhead could occur. The screw should only be ¼ turn beyond
hand tight.