Filter
Top Products
1-20
Chapter 1: Product introduction
1.12 Connectors
This section describes and illustrates the internal connectors on the motherboard.
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the floppy
drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables
with pin 5 plug).
2. Serial port 1 connector (10-1 pin COM2)
This connector accommodates a second serial port using an optional serial
port bracket. Connect the bracket cable to this connector then install the
bracket into a slot opening at the back of the system chassis.
The serial port (COM2) bracket is purchased separately.
P4P800-VM
®
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
P4P800-VM Floppy Disk Drive Connector
PIN 1
FLOPPY1
P4P800-VM
®
P4P800-VM Serial COM2 Bracket
PIN 1
COM2