Filter
Top Products
ASUS P4P800-VM motherboard user guide
1-21
3. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
This connector supports the provided UltraDMA100/66 IDE ribbon cable. Connect
the cable’s blue connector to the primary (recommended) or secondary IDE
connector, then connect the gray connector to the UltraDMA100/66 slave device
(hard disk drive) and the black connector to the UltraDMA100/66 master device. It
is recommended that you connect non-UltraDMA100/66 devices to the secondary
IDE connector. If you install two hard disks, you must configure the second drive
as a slave device by setting its jumper accordingly. Refer to the hard disk
documentation for the jumper settings. BIOS supports specific device bootup. If
you have more than two UltraDMA100/66/33 devices, purchase another
UltraDMA100/66/33 cable. You may configure two hard disks to be both master
devices with two ribbon cables – one for the primary IDE connector and another
for the secondary IDE connector.
P4P800-VM
®
P4P800-VM IDE Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
SEC_IDE1
PRI_IDE1
PIN 1
Refer to the Parallel ATA and Serial ATA device configurations on the next page.
Important note when using legacy OS
Refer to page 1-22 on how to configure P-ATA and S-ATA devices if you
installed a legacy operating system (e.g. MS-DOS, Windows 98/Me/NT4.0).
1. Pin 20 on each IDE connector is removed to match the covered hole on the
UltraDMA cable connector. This prevents incorrect orientation when you
connect the cables.
2. The hole near the blue connector on the UltraDMA100/66 cable is intentional.
3. For UltraDMA100/66 IDE devices, use the 80-conductor IDE cable.