Filter
Top Products
ASUS P5W DH Deluxe 5-49
Building a RAID 1 set for the rst time
The ASUS EZ-Backup advantage is that you can build a RAID 1 set without any jumper
or BIOS setting. When creating a RAID 1 set for the rst time, you can follow these simple
steps.
1. Prepare two Serial ATA hard disk drives (HDDs). Plug one end of the Serial
ATA cable to the rear interface on each drive and plug the other end of the
cable to the motherboard connectors labeled EZ_RAID1 and EZ_RAID2
(colored light orange). Refer to section “2.7.2 Internal connectors” for the
location of the connectors.
For best results, use Serial ATA 3.0 Gb/s hard disk drives listed in the
EZ-Backup compatibility list. Visit the ASUS website at www.asus.com for
details.
2. Connect a Serial ATA power cable or a 4-pin legacy power connector from
the power supply unit to the rear power connector on each drive.
Using both the SATA power cable and 4-pin power connector simultaneously
will cause damage to the system.
3. Install the operating system.
4. Install the ASUS EZ-Backup Manager utility from the support CD that came
with the motherboard package.
5. Reboot the computer.
3. BIG is storage policy in which multiple physical drives are concatenated
and treated as one large volume. This conguration allows you to increase
virtual volume size beyond the capacity of individual drives. Big provides the
maximum amount of storage space, but no additional performance or data
redundancy.
To implement the Big storage policy, the ASUS EZ-Backup Manager
concatenates both hard drives into a single volume.
.
Before creating a RAID set
Prepare the following items:
1. Two Serial ATA hard disk drives (HDDs)., preferably with the same model and
capacity.
2. Motherboard support CD with ASUS EZ-Backup Manager