Filter
Top Products
17
(','/($51,1*
EDID learning is needed whenever the user has certain HDMI displays that cannot output
audio/video properly. This could happen when the HDMI displays connected to the matrix have
different capability output HDMI signals. If that happends, please enter the EDID learning mode
and make all input ports learn the EDID from the display with lowest capability for HDMI signals.
Note
SW1-SW8 Pin-1 must be set “ON” for EDID Learning Mode
DIP Switch Position
Video Audio Description
Pin-1
ON [ª]
Bypass Stereo
EDID Learning – for learning EDID from the receiver
Method A: Manually connect HDMI display to HDMI INPUT
Please see the section
“DIP Switch”
Method B: Using Front Panel
1. Push the SELECT button until the LED display of PRESET PROFILES shows “E” to enter the
EDID Learning Mode.
2. Press Up () button or Down (ï) button to choose which output display's EDID will be learned
by each input port, and the number of the chosen output display will be shown on the LED
display.
3. Each input port of the matrix can learn the same or differently chosen display's EDID at the
same time.
4. The LED display on each port will show “H” if the user decide the input port to keep the
curretnly stored EDID.
5. After the EDID learning configuration is finished, press SAVE button to proceed EDID learning
sequence on all HDMI input ports.
6. Each LED of the input port will show “O” (OK) if the operation is successful or “F” (Failed) if
not successful. Please repeat the procedure from step 1 if any port shows “F”.