Filter
Top Products
xvii
ATTO Technology Inc. FastStream VT 5300 Installation and Operation Manual
RMStatus
Displays the status of all RAID Members within the
specified RAID Group or a specific RAID member (if
specified) within the specified RAID Group. This
command fails if the specified RAID Group does not exist
or a specified member index within the RAID Group does
not exist.
RMStatus [GroupName] <MemberIndex>
Route
Assigns a SCSI LUN protocol address to a target. Use the
Delete
identifier to remove the map. In verbose mode,
overwriting a map requires secondary confirmation of
the action.
Route FC [lun] [ [RAID [GroupName] | Delete ]
RouteDisplay
Displays a list of Fibre Channel to SCSI address
mappings on the FastStream.
RouteDisplay FC <fp> <fl>
SaveConfiguration
Issued with the restart option, cycles unit power after
saving configuration changes. The
norestart
option
saves changes without restarting.
Note
Certain modifications require a system restart.
SaveConfiguration <Restart | NoRestart>
SCSIInitID
Specifies or reports the SCSI initiator ID on the specified
SCSI port as found in NVRAM. All maps coinciding with
the user-specified
SCSIInitID
are destroyed after the
command is issued.
Default: 7
set SCSIInitID [sb [0-15] ]
get SCSIInitID
SCSIPortBusSpeed
Controls the transfer rate at which the unit attempts to
negotiate with its SCSI devices.
Default: ultra320
set SCSIPortBusSpeed [sb] [fast | ultra | ultra2 | ultra160
| ultra320]
get SCSIPortBusSpeed [sb]
SCSIPortList
Returns a list of available SCSI ports and their current
status. Valid status values are OK and Failed
SCSIPortList
SCSIPortReset
Resets the specified SCSI bus.
SCSIPortReset [sb]
SCSIPortResetOnStartup
Specifies if the SCSI port should be reset on power-up.
Default: enabled
set SCSIPortResetOnStartup [sb [enabled | disabled] ]
Requires a SaveConfiguration command
get SCSIPortResetOnStartup [sb]
SCSIPortSyncTransfer
Specifies whether synchronous SCSI transfers should be
negotiated with devices on the specified SCSI port.
Default: enabled
set SCSIPortSyncTransfer [[sb [enabled | disabled] ]
Requires a SaveConfiguration command
get SCSIPortSyncTransfer [sb]
SCSIPortTermination
Configures/reports the SCSI internal termination of the
SCSI port identified on the FastStream.
Default: enabled
set SCSIPortTermination [sb] [enabled | disabled]
Requires a SaveConfiguration command
get SCSIPortTermination [sb]
SCSIPortWideTransfer
Specifies whether wide SCSI transfers should be
negotiated.
Enabled
allows wide transfer negotiation
Default: enabled
set SCSIPortWideTransfer [sb [enabled | disabled ]]
Requires a SaveConfiguration command
get SCSIPortWideTransfer
SCSITargetLUNs
Sets the maximum number of SCSI LUNs per target the
FastStream tries to query during a SCSI bus scan.
Default: 8
set SCSITargetLUNs [sb] [8 | 64]
Requires a SaveConfiguration command
get SCSITargetLUNs
SCSITargets
Returns a list of SCSI devices operational on the
referenced SCSI port with SCSI target number, SCSI
LUN number, device type, vendor ID, product ID,
revision and serial number.
SCSITargets [sb]
SerialNumber
Reports the FastStream serial number which is unique for
each FastStream. The serial number tracks the board
throughout its life and should not be changed.
get SerialNumber