Filter
Top Products
xviii
Appendix
SerialPortBaudRate
Configures the baud rate for the unit’s RS-232 serial port.
The number of data bits is fixed at
8
with no parity.
set SerialPortBaudRate [ 2400 | 9600 | 19200 | 38400 |
57600 | 115200]
get SerialPortBaudRate
SerialPortEcho
Controls if the unit echoes characters on its RS-232 port.
When enabled, all non-control character keyboard input
is output to the display.
Default: enabled
set SerialPortEcho [enabled | disabled]
get SerialPortEcho
SNTP
Controls whether SNTP time server is used.
Default: enabled
set SNTP [enabled | disabled]
get SNTP
SNTPServer
Controls or displays the main IP address the client uses
to retrieve the SNTP time.
Default: 192.43.244.18
set SNTPServer[xxx.xxx.xxx.xxx]
get SNTPServer
TailEventLog
Displays new events to the terminal. Type
q
and press
Enter
to exit tail mode.
TailEventLog
TapeLibDelete
Deletes the specified tape library or all tape libraries.
TapeLibDelete [GroupName | all]
TapeLibInfo
Lists information for the specified tape library or all tape
libraries.
TapeLibInfo [LibName | all]
TapeWriteProtect
Enables or disables write protection for a
particular virtual tape or both virtual tapes.
set TapeWriteProtect [TapeVol ID | all] [enabled |
disabled]
get TapeWriteProtect
Time
Controls or displays the current time as clocked by the
unit in 24 hour format. Time cannot be set while SNTP is
enabled.
set Time [HH: MM: SS]
get Time
TimeZone
Controls or displays the time zone or an offset from GMT
for the unit.
set TimeZone [[EST | CST | MST | PST] | [+/-HH:MM]]
get TimeZone
Username
Specifies the username used for all sessions: NDMP,
Telnet, FTP and Webserver. Username is case
insensitive, 1 to 32 characters, and cannot contain
spaces.
Default: root
set Username [username]
get Username
VerboseMode
Controls the level of detail in CLI
Help
output and
command response output for the current CLI session.
Default: enabled
set VerboseMode [enabled | disabled]
get VerboseMode
VirtualDriveInfo
Displays characteristics and statistics for all the
available virtual drives or any available virtual drive
identified by its virtual drive ID.
VirtualDriveInfo <VirtualDrive ID>
Voltage
Displays the voltage levels monitored by the FastStream.
Representations of the voltages are
VDDA: +3.31 V
VDDB: +2.49 V
VDDC: +1.5V
VDDD: +1.35V
ALL: all monitored voltages
get Voltage <VDDA |VDDB |VDDC VDDD | all>
WrapEventLog
When enabled, the FastStream logs up to 2,048 event
entries before wrapping (overwriting the first entries). If
disabled, the FastStream stops logging event entries
when the buffer is full.
Default: enabled
set WrapEventLog [enabled | disabled]
get WrapEventLog
zModem
Uses the zMODEM protocol to transfer a file to or from
the unit via the RS-232 port. The filename to retrieve is
required if the
send
option is specified.
Zmodem [send [filename] | receive]