Page 1
Model APS-350-A
Installation Manual
SELECTABLE FEATURES
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order
to begin the passive arming sequence.
RF Programmable Features :
Feature Selection 1 Chirp 2 Chirps Default
First 1 Second Door Locks 3.5 Second Door Locks 1 Second
Second Auto Lock On Auto Lock Off Auto Lock Off
Third Auto Unlock On Auto Unlock Off Auto Unlock Off
Fourth Passive Door Locks Active Door Locks Active Locks
Fifth Passive Arm Active Arm Passive Arm
Sixth Voltage Sense Hardwire Hardwire On
Seventh Horn Chirps On Horn Chirps Off Horn Chirps On
Eighth Siren Chirps On Siren Chirps Off Siren Chirps On
To program these selectable features;
Action System Response LED Response
Turn ignition on No response
Flip valet switch on then off 3 times 1 Chirp - LED 1 flash
Within 3 seconds, turn ignition Off Short chirp, then long chirp
First Within 3 seconds, turn ignition On 1 chirp = 1 second door locks 1 Flash Pause...
Press transmitter button 1 to change 2 chirps = 3.5 second door locks
or
Second Flip valet switch on then off 2 chirps = auto locks off 2 Flash Pause...
Press tranmitter button 1 to change 1 chirp = auto locks on
or
Third Flip valet switch on then off 2 chirps = auto unlock off 3 Flash Pause...
Press transmitter button 1 to change 1 chirp = auto unlock on
or
Fourth Flip valet switch on then off 1 chirp = passive locks 4 Flash Pause...
Press transmitter button 1 to change 2 chirps = active locks
or
Fifth Flip valet switch on then off 1 chirp = Passive Arm 5 Flash Pause...
Press transmitter button 1 to change 2 chirps = Active Arm
or
Sixth Flip valet switch on then off 1 chirp = Voltage sense on 6 Flash Pause...
Press transmitter button 1 to change 2 chirps = Hardwire
or
Seventh Flip valet switch on then off 1 chirp = Horn chirps on 7 Flash Pause...
Press transmitter button 1 to change 2 chirps = Horn chirps off
or
Eighth Flip Valet Switch on then off 1 chirp = Siren chirps on 8 Flash Pause...
Press transmitter button 1 to change 2 chirps = Siren chirps off
or
Flip valet switch on then off Exit program mode
or
Turn ignition key off Exit program mode
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the
programming will be terminated.
