Filter
Top Products
-11-
128-6423
11 of 16
Optional Accessories
Wired Headphone
There are two 1/8” headphone jacks on the VOH703
that can be used with any standard stereo
headphones. The jack, TV EAR, is used to listen to
the video program audio. The audio volume is
controlled by the TV VOLUME up/down buttons.
Remove the protective plastic cover to access the
jacks. Remember to replace the cover when the
jacks are not in use.
Wired FM Modulator
Your video system may be equipped with an RF
modulator, that allows you to listen to the VOH703’s
video audio signal by tuning your vehicle’s radio to
the selected frequency, (88.7 or 89.1 - Check with
your installer) and turning on the remote mounted
RF modulator switch. (In most cases this toggle
switch will be located underneath the driver’s side of
the dash, check with your installer for the exact
location.) Whenever the RF modulator is on,
broadcast radio reception of the vehicle’s radio will
be diminished. Setting the remote mounted toggle
switch off will allow normal radio reception.
Video Output
The VOH703 provides a video output for an optional
video monitor(s). (Refer to page 6 of the installation
guide for more details.) This output will provide a video
signal that duplicates the signal displayed by the
VOH703 to an additional monitor or video display.
Please see your installer for more information.
on its face. The VOH703 is now ready to play the
audio and video signals from the VCP if it is connected
to the “Video 1” input. Inserting a tape into the VCP
will turn it on and automatically activate the play mode.
If a rewound tape had already been loaded into the
VCP, prior to its activation press play on the VCP or
on the remote control to view the tape. For more
information see the operator’s manual accompanying
your VCP.
Audiovox Video Cassette Player (Aux Video 1)
In most installations a VCP will be connected to the
“Video 1” input. To view a video cassette, turn the
VOH703 On and press the source button on its control
panel or the TV / Video button on the remote control
until “Video 1” is displayed on the screen. The VCP
may also be operated with the remote or the buttons