Filter
Top Products
Cajun P550/P880/P882 Switch User Guide
10-1
10
Configuring the Routing
Information Protocol (RIP)
Overview
* Note: You must globally enable RIP before it can be
configured. To globally enable RIP, refer to “Creating an
IP Interface”, and “Configuring Virtual Redundant
Router Protocol (VRRP)”, in Chapter 9, "Configuring IP
Routing".
The information and procedures provided in this chapter pertain to
layer 3 module configuration only:
This section describes:
■ Configuring RIP on the Switch
■ Modifying RIP Interfaces
■ Creating Trusted RIP Neighbors
■ Viewing RIP Statistics
Configuring RIP on the Switch
You can configure the RIP from either the web agent or the CLI.
Configuring RIP
on the Switch
Using the Web
Agent
To configure the RIP globally on your switch using the web agent:
1. Select Global Configuration from the Routing > IP > RIP
group on the Web Agent window. The RIP Global
Configuration dialog box opens (Figure10-1).