Filter
Top Products
Cajun P550/P880/P882 Switch Configuration Guide
Configuring AppleTalk Routing
15-11
3. Refer to Table15-2 to configure the Add AppleTalk Static
Route dialog box parameters.
4. Click CREATE to add the static route, or CANCEL to restore
previous settings.
Creating an
AppleTalk Static
Route Using the
CLI
To create an AppleTalk static route using the CLI, enter the following
command in Configure mode:
> (config if-<interface-name>:)# appletalk
static cable-range <cable-range> to <network.node>
[floating] zone <zone-name>
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about this command.
Table 15-2. Add AppleTalk Static Route Dialog Box Parameters
Parameter Definition
Network Range
Start
Enter the starting network number. The network
number specifies the range of AppleTalk network
numbers for extended networks. Each number in the
range must be an integer between 1 and 65279.
Note: Network Range Start must be less than or
equal to Network Range End.
Network Range
End
Enter the ending network number. The network
number specifies the range of AppleTalk network
numbers for extended networks. Each number in the
range must be an integer between 1 and 65279.
Network
Number
Enter the next hop network number. This number
specifies the network number of the next hop router
for the network range.
Node Enter the next hop node identification number. This
number must be between 1 and 253.
Type Select the type of static route. The options include:
• High - The static route is not superseded by a
route update.
• Low - The static route can be superseded by a
route update.
Zone Enter an AppleTalk zone name assigned to this route.
Zone names may be up to 32 characters in length.