Filter
Top Products
15-16
Chapter 15
Cajun P550/P880/P882 Switch Configuration Guide
Editing an AppleTalk NBP Filter
You can edit an AppleTalk NBP filter using either the web agent or
the CLI.
Editing an
AppleTalk NBP
Filter Using the
Web Agent
To edit an AppleTalk NBP filter using the web agent:
1. Select NBP Filter from the Routing > AppleTalk >
Configuration group on the web agent window. The
AppleTalk NBP Filter dialog box opens (Figure15-8).
2. Refer to Table15-3 to edit the AppleTalk NBP Filter dialog
box parameters.
3. Click ...
— CREATE to add a new filter. The Add AppleTalk NBP
Filter dialog box opens. See “Creating an AppleTalk NBP
Filter”, earlier in this section, for more information.
— DELETE to remove the selected NBP filter.
— CANCEL to restore previous settings.
— Edit If to add or delete this NBP filter to/from an
interface. The Add/Delete Interface to NBP Filter dialog
box opens. See “Adding or Deleting Interfaces to NBP
Filter”, later in this section, for more information.
Editing an
AppleTalk NBP
Filter Using the
CLI
To edit an AppleTalk NBP filter using the CLI, enter the following
command in Configure mode:
> (config-if <interface-name>:)# appletalk
access-list <access-list-number>
<permit|deny> nbp <string>
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about this command.