Filter
Top Products
Substitute Power Supply - LUFIXP
Installation and Connection Instructions for Substitute Power Supply
This kit (COM Code 408475895) contains the necessary hardware to provide power to a PagePac
®
Plus Controller
(COM Code 406914598). This kit is used if the controller is powered directly from the amplifier and does not use a sep-
arate power supply and that amplifier is being replaced with an amplifier that does not have the facility to power the con-
troller directly.
Installation and Connections: (Refer to diagram on back when making connections)
1) Power down the entire paging system.
2) Disconnect the existing amplifier’s cable from the “FROM AMP” and “TO AMP” connectors on the controller and com-
pletely remove the existing amplifier from the installation.
3) Mount the replacement amplifier following the installation instructions included with the amplifier. Make sure that
LUFIXP cables will reach from the controller’s location to where the replacement amp is located.
4) Plug the LUFIXP cable with the 8-pin connector into the controller’s “FROM AMP” connector.
5) Connect the RJ11 cable from the LUFIXP to the controller’s “TO AMP” jack.
6) Connect the LUFIXP cable with the 2 spade lugs to the amplifier’s output terminals.The Red/White wires are connect-
ed to the “70V” output terminal and Black/Green wires are connected to the amplifier’s COM terminal (leave any exist-
ing shorting clips on the terminals in place).
7) Connect the LUFIXP cable with 4 conductors and a shield to the input section of the replacement amplifier as follows:
WHITE - TEL
GREEN - COM
Shield - GND
BLACK - “T”
RED - “R”
8) Attach both AC power cords to the LUFIXP power supplies and mount the supplies to an available surface using the
velcro strip included.
9) Plug in both power cables (in any order) and power up the paging system.
CAUTION - all wiring must be completed before applying power to the system.
10) Quick Test: PagePac Controller’s power LED should be on, then turn up the amplifier’s TEL VOLUME and make a
page (set volume to appropriate level).
11) Refer to the replacement amplifier’s instructions manual for making final control setting adjustments.
Select Code 701-000-140
Issue 4, March 2003
COM Code 408475895
© 2000 Bogen Communications, Inc.
All rights reserved. 54-2040-01C
PagePac is a registered trademark of Valcom Inc.
For use with amplifier-powered PagePac
®
Controllers when replacing Harris
Amplifiers with LU35WAMP, LU100WAMP or LU250WAMP amplifiers
(408186070) (408186088) (408186096)
CONTROLS
TEL
BAL