Filter
Top Products
3
CHAPTER
2
Installation
AutoView 3050/3100/3200 Switch Connectivity
The AutoView 3050/3100/3200 switching system transmits keyboard, video and mouse (KVM)
information between operators and target devices attached to the switch over a network using either
an Ethernet or modem connection.
The AutoView 3050/3100/3200 switch uses TCP/IP for communication over Ethernet. Although
10
BaseT Ethernet may be used, Avocent recommends a dedicated, switched 100BaseT or
1000BaseT network for switches that support it.
Installation Overview
The general procedure for setting up and installing an AutoView 3050/3100/3200 switch is as
follows:
• Unpack the switch and verify that all components are present and in good condition.
• Make all hardware connections between the power source, switch, target devices, the Ethernet
and
the optional modem connection.
• Turn on the power and verify that all connections are working.
• Configure the AutoView 3050/3100/3200 switch’s IP address using the OSCAR graphical user
interf
ace.
• Use the On-board Web Interface (OBWI) to configure the AutoView 3050/3100/3200 switch.
• Make the appropriate mouse setting adjustments.