Filter
Top Products
Chapter 5: CCM Appliance Commands 57
Port Alert Add command
The Port Alert Add command adds a port alert string to a specified port. Each port may have up to
ten port alert strings. Duplicate strings are not allowed on the same port. To generate a trap, the
Server SNMP Trap command must be issued to enable the PortAlert trap. For more information,
see Managing the CCM Appliance Using SNMP on page 39.
Access right: SCON or PCON
Access level: ADMIN or APPLIANCEADMIN
Syntax
PORT <port> ALERT ADD “<string>”
Port Alert Copy command
The Port Alert Copy command copies the alert strings from one port (from_port) to another
(to_port). Any alert strings that were previously defined on the to_port will be deleted. When you
enter this command, you are prompted to confirm or cancel the copy operation.
For more information, see Managing the CCM Appliance Using SNMP on page 39.
Access right: SCON or PCON
Access level: ADMIN or APPLIANCEADMIN
Syntax
PORT <to_port> ALERT COPY <from_port>
Port History Accesses a port’s history mode.
Port Logout Terminates the CCM session on a specified port.
Port NFS Enables or disables using the NFS feature on a port.
Port Set Changes CCM serial port settings for one or all ports.
Port Set In/Out
Specifies how carriage returns and linefeeds are treated in incoming or outgoing
serial data.
Table 5.5: Port Command Summary (Continued)
Command Description
Table 5.6: Port Alert Add Command Parameters
Parameter Description
<port> Port number or name.
<string>
3-32 character string. If the string contains embedded spaces, it must be enclosed
in quotes.