Avocent CCM Network Card User Manual


 
66 CCM Installer/User Guide
At least one parameter must be specified.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER CLI [TYPE=<type>] [CHAR=^<char>] [CONNECT=ON|OFF]
[HISTORY=HOLD|AUTO,CLEAR|KEEP] [MODEMINIT=“<string>”]
[TIMEOUT=<time-out>]
Table 5.14: Server CLI Command Parameters
Parameter Description
TYPE=<type>
Terminal type to be used on the console port. The entire name of the type must
be specified; abbreviations are not permitted. Valid types are: ASCII, VT52,
VT100, VT102, VT220 and VT320.
Default: ASCII
CHAR=^<char>
CLI access character in the range A through _ (underscore). (The allowable
ASCII range is 0x41-0x5F and 0x61-0x7A.) The CLI access character, when
pressed simultaneously with the
Ctrl key during a session with an attached
serial device, will suspend the session with the device and place you in CLI
command mode. This value will be used if a port’s Port Set command contains a
Char=None parameter.
Default = ^d
CONNECT=ON|OFF
Enables or disables the ability to use the Connect command from the console
port. When enabled, a console port user may use the Connect command to
establish a connection to the serial device attached to another CCM appliance
serial port. When disabled, you cannot use the Connect command from the
console port.
Default = ON
HISTORY=HOLD|AUTO
,CLEAR|KEEP
Port history file processing options during connection (Hold or Auto) and when a
session ends (Clear or Keep):
Hold Upon connection you are informed of how much data is in the history
buffer, but the data is not displayed.
Auto Upon connection you are informed of how much data is in the history
buffer, and it is then displayed.
Clear The history buffer’s content is cleared when a session ends.
Keep The history buffer’s content is retained when a session ends.
You cannot specify both Clear and Keep or both Hold and Auto.
Default = HOLD,CLEAR
MODEMINIT=“<string>”
Modem initialization string, enclosed in quotation marks. Must contain at least
ATV1 and S0=1.
Default = “” (no modem is attached to the console port)