Filter
Top Products
Chapter 5: CCM Appliance Commands 59
Show Port command
The Show Port command displays configuration and status information about one or all ports.
Access right: SMON
Access level: ADMIN or APPLIANCEADMIN
Syntax
SHOW PORT [<port>|ALL|NAMES]
The SHOW PORT NAMES command display includes the port numbers and names. If a port has
not been given a name with a Port Set command, the default name is displayed. A default name
contains the last three octets of the MAC address plus the port number.
Table 5.24 lists the display fields for a Show Port command that specifies one or all ports.
Show Server SNMP Displays SNMP configuration information.
Show User Displays user configuration and session information.
Table 5.22: Show Command Summary (Continued)
Command Description
Table 5.23: Show Port Command Parameter
Parameter Description
<port>
Either a port number in the range 1-48 or CON.
Default = your port
ALL Displays information about all ports.
NAMES Displays port numbers and associated logical names.
Table 5.24: Show Port Command Display Fields
Field Content
Port Port number.
Serial Port Settings
Comma-separated string of port values: baud rate, number of bits, parity, stop bits,
flow control, socket number, time-out value and CLI access character (from Port Set
command). The CLI character is preceded by POR CLI= if it was defined with a Port
Set command or by SER CLI= if it was defined with a Server CLI command.
TX Bytes Number of bytes transmitted.
RX Bytes Number of bytes received.
Errors Number of TX/RX parity and framing errors.