Barco HDX W20 Projector User Manual


 
3. Physical installation
3. PHYSICAL INSTALLATION
About this projector
This chapter describes how the mechanical set up of the projector has to be done and how to realize the electrical connections.
Overview
Remote control unit (RCU)
Lenses
Connecting the projector with the power net
Alignment of a table mounted projector
Mounting the bottom carry handler
Mounting the top carry handler
Suspension of the projector with rigging clamps
Alignment of a ceiling mounted projector
3.1 Remote control unit (RCU)
Introduction
The remote control unit (A) of the HDX projector is equipped with a rugged case (B) and an XLR adaptor (C). The remote control
unit can be used wired via mini-jack or via rugged XLR. Note that the backlight, of the remote control unit, illuminate continuously
when wire connected.
C
B
A
Image 3-1
A Remote control unit (RCU).
B Rugged case.
C XLR adaptor.
Overview
RCU battery installation
RCU rugged case installation
RCU XLR adaptor installation
Using the XLR adaptor of the RCU
RCU usage possibilities
3.1.1 RCU battery installation
Where to nd the batteries for the remote control ?
The batteries are not placed in the remote control unit to avoid control operation in its package, resulting in a shorter battery life
time. At delivery the batteries can be found in a separated bag attached to the remote control unit. Before using your remote control,
install the batteries rst.
R5905032 HDX SERIES 02/03/2015
23