Filter
Top Products
3. Connections
3.6.1 RS232
Application
1. Remote control :
- easy adjustment of projector via an IBM PC (or compatible) or MAC connec tion.
- allow storage of multiple projector configurations a nd set ups.
- wide range of c ontrol possibilities.
- address range from 0 to 255.
2. data communications : sending data to the projector or copying the data from the projector to a har d memory device (hard disc,
floppy, etc.).
How to connect ?
1. Connect the serial communication port of computer or Apple MacIntosh to the RS232 in port of the projector. (image 3-8)
Image 3-8
RS232 connection to projector
Set up of the Baud rate for communication.
see Change Baudrate P C, page 81in chapter Ser vice mode.
3.6.2 Communication with peripherals
Configuration of the port.
This port can be configured to accept PPM or RC5 coded signals. To change the port configuration see Defining the Infrared Com-
munication protocol, page 73 in Chapter Installation.
What is possible with an RCVDS05 connected.
• Up to 20 inputs with the RCVDS 05 and 90 inputs when RCVDS’s are linked via the expansion module.
• Serial communication with the projector.
• Remote control buttons on the RCVDS to contr
ol the projector (source selection and analog settings).
• The selected source number will be displayed on a 2 digit display and the s elected input module will be indic ated with a LED
on the rear.
For more information about the use of the RCVDS05, consult the owner’s m anual of the RCVDS05.
3.6.3 Mouse
When available ?
Mouse function is only available with the Executive R emote Control (Order number : R9829 960). The computer can then be con-
trolled via the projector.
R5976182 BARCOREALITY 6500 30012001
25