Filter
Top Products
Rev. 1.00
- 53 -
SRP-F310/312
6. Adjustments and Maintenance
6-1 Adjustment
6-1-1 Remaining Roll Paper Adjustment
This sensor is set to the step4 position at the factory. If you find that there is not or too enough paper
remaining on the roll when the near-end sensor is triggered, you can change the setting to the upper or
Lower position as described below.
Note: The factory setting is based on a paper roll core with an outside diameter of 18mm. If you use a paper
roll with a core with an outside diameter of more than 18mm, it is better to change to the upper
position(Rotate the tab at front side) as described below.
1. Open the paper roll cover.
2. Rotate the tab at front or rear Position.