Filter
Top Products
CHAPTER 4 CONTROL PANEL
4–47
✒ Note
Do not forget your pass number that you have used to lock the panel
switches. If you enter a wrong number, you cannot unlock them. The
display shows the following message:
INCORRECT!!
■ Auto Form Feed
If unprinted data remains in the printer’s memory, the DATA lamp stays
on. You need to print out the remaining data with the FORM FEED
switch. See “FORM FEED Switch” in Chapter 4.
The auto form feed you can set in this mode menu allows you to print out
the remaining data without pressing the FORM FEED switch.
You can turn on or off the auto form feed in this mode menu as follows:
Display Message Auto Form Feed
AUTO FF=OFF Turn off the auto form feed. You need to
press the FORM FEED switch every time
data remains in the printer’s memory.
(Factory setting)
AUTO FF=ON Turn on the auto form feed. Every time data
remains in the printer’s memory, the auto
form feed takes place after the wait time set
as below.
When you turn on the auto form feed as above, you need to set the wait
time in the following sub-setting menu:
Display Message Wait Time
WAIT TIME= 1s Set the wait time for the auto form feed.
.
The printer automatically prints out the
.
remaining data after the set wait time.
WAIT TIME=99s The wait time can be set from 1 to 99
seconds.