Filter
Top Products
LS6233040
ARL/ASA/NZ
Printed in China
Before you can use the machine, read this Quick Setup Guide
for the correct setup and installation.
Turn the sheet over.
Quick Setup Guide
DCP-385C
Install the ink cartridges
5
d. Unpack the ink cartridge.
Turn the green knob on the protective yellow cap
clockwise until it clicks to release the vacuum seal,
then remove the cap a.
If all lines are clear and visible, press
(Yes) to finish the quality check.
If you can see missing short lines, press
(No) and follow the steps on the LCD.
o
o
Set the LCD contrast (If needed)
76
Check the print quality
c. Remove the green protective part a.
OK
Poor
Set the date and time
8
a. Press Menu.
b. Press a or b to choose General Setup.
press OK.
c. Press a or b to choose LCD Settings.
press OK.
d. Press a or b to choose LCD Contrast.
e. Press d or c to choose Light, Med or Dark.
press OK.
f. Press Stop/Exit.
Note
You can also adjust the angle of the display by
lifting it.
a. Press Menu.
b. Press a or b to choose
Initial Setup, and then press OK.
c. Press a or b to choose
Date&Time, and then press OK.
b. Check the quality of the four colour
blocks a on the sheet.
(black/yellow/cyan/magenta)
Unpack the machine and check the components
1
b. Remove the green protective packing a
by lifting the front of the machine and then
pulling down on the packing part.
c. Remove the plastic bag b containing the ink
cartridges from on top of the paper tray.
Plastic bags are used in the packaging of your machine.
To avoid danger of suffocation, please keep these bags
away from babies and children.
WARNING
d. Fan the stack of paper well.
e. Gently put the paper into the
paper tray. Check that the paper
is flat in the tray.
f. Gently adjust the paper side
guides to the paper with both
hands.
Make sure the paper side
guides touch the edges of the
paper.
g. Close the paper tray cover
and slowly push the paper
tray back into the machine.
h. Pull out the paper support a until
it clicks, and then unfold the paper
support flap b.
Important
Do not push the paper
in too far.
a. Connect the power cord.
The machine must be fi tted with an earthed plug.
WARNING
Connect the power cord
3
e. Install each ink cartridge in the direction
of the arrow on the label.
Take care to match the colour of the
lever a with the cartridge colour b.
Start Here
WARNING
Warnings tell you what to do to
prevent possible personal injury.
Important
DO NOT
connect the
USB cable yet.
a. The LCD shows:
b. Open the ink cartridge cover a.
a. When the preparation process
has finished, the LCD shows this
message.
Press Colour Start.
Note
The components of your box may differ depending on your
country.
Save all packing materials and the box in case for any
reason you must ship your machine.
Your machine has a USB interface that is compatible with
the USB 2.0 specifi cation.
To ensure safe operation the supplied plug must be inserted
only into a standard power outlet that is properly grounded
through the standard electrical wiring. Non grounded
equipment may cause an electrical shock hazard, and may
cause excessive electrical noise radiation.
•
•
•
•
a. Remove the protective tape and film.
Set the language (not available for Hong Kong users)
4
a. After connecting the power
cord, the LCD shows:
Press a or b to choose your
language and press OK.
b. Choose Yes or No and press
OK.
f. Gently push the ink cartridge until it clicks. After all the ink
cartridges are installed close the ink cartridge cover.
d. Press a or b repeatedly to enter the last two digits of
the year, and then press OK.
(e.g. Enter 08 for 2008.)
e. Repeat for Month and Day, and Hours and Minutes
in 24-hour format.
f. Press Stop/Exit.
Important
DO NOT connect the USB cable
yet.
Note
The control panel warning
LED will stay on until you have
installed the ink cartridges.
Important
After initial installation of the ink cartridges, the machine will start cleaning the
ink tube system. This cleaning process will last approximately four minutes.
DO NOT unplug the machine from the power outlet or attempt to stop the
cleaning process. Interruption of cleaning process may cause undesired print
quality problems.
Australia & New
Zealand
Hong Kong,
Malaysia &
Singapore
Philippines &
Thailand
The supplied mains plug is a
grounded three pin plug.
The supplied mains plug is
a side grounded two pin plug.
d. Make sure you have all components.
2
Inbox Ink
Cartridges [x4]
1
Black
Yellow
Cyan
Magenta
Power Cord
USB
Interface
Cable
CD-ROM
User’s Guide
Quick Setup
Guide
1
Approx. 65% yield of the replacement cartridge. For details, see
Consumable items in the User’s Guide.
Note
The languages available may differ depending on your country.
If you set the wrong language, you can change it again after setting the
date and time. (For details see Changing LCD language in Chapter 3 of the
User’s Guide.)
•
•
Note
If you make a mistake and want to start again,
press Stop/Exit to go back to step a.
1
1
2
1
1
1
2
1
1
2
a. Pull out the paper tray.
b. Lift the paper tray cover a.
Load plain A4 paper
c. Press and slide the
paper side guides a and
paper length guide b to
fit the paper size.
Make sure that the
triangular marks c on
the paper side guides a
and paper length guide
b line up with the mark
for the paper size you
are using.
1
1
3
3
2
1
1
Select Language
Select Language
Select & Press OK
Deutsch
Nederlands
Italiano
Français
English
English
Select Language
Select & Press OK
No
Yes
No Cartridge
Black
Install Ink
Set Paper and Press
Start
Date&Time
Year:20
08
MENU Input & Press OK