Filter
Top Products
9
STEP
1
STEP
2
STEP
3
For WindowsFor Macintosh
STEP
4
Getting started
Reference Installing the software
Label overview
Introduction
Connect the power cord to the Brother QL-570
and then plug the power cord into a electrical
outlet.
• Check that the electrical outlet is 120V AC before
plugging the power cord.
• Unplug the power cord from the electrical outlet
after you have finished using the Brother QL-570.
• Do not pull the power cord when unplugging it from
the electrical outlet. The wire in the power cord may
become damaged.
• Do not connect the Brother QL-570 to the computer
until directed to do so when installing the printer
driver.
3
Thread the end of the DK Roll into the
slot until it align to the area shown
right.
Align the end of the roll with the upright
edge of the label output slot.
4
Close the DK Roll compartment cover.
When you press the ON/OFF button ( ) to
turn the Brother QL-570 on, the end of the
DK Roll is aligned automatically.
4 Connecting the power supply