Cabletron Systems CSX500 Switch User Manual


  Open as PDF
of 2
 
PN 9032534-03 Page 1 of 2
CSX500 SETUP GUIDE
PRE-CONFIGURATION INFORMATION
This Setup Guide describes the tools needed to configure the CyberSWITCH CSX500.
Figure 1 shows the CyberSWITCH CSX500.
Figure 1 The CSX500
QuickSet CONFIGURATION SETUP
Tools needed
The following tools are required to configure the CSX500:
• Personal Computer (PC)
•
Read Me First!
instruction sheet (enclosed in the manual package)
• QuickSet CD (located in the shipping box with your device)
Only qualified personnel should install the CSX500. This Setup Guide is intended for the experienced
network equipment installer.
NOTE
For further details concerning the operation of the CSX500, refer to the HSIM-W84 documentation on
the QuickSet CD. The HSIM-W84 is similar to the CSX500. The difference is that the HSIM-W84 is a
module that is installed into a host device, while the CSX500 is a standalone unit. All other information
pertaining to the device is the same.
NOTE
Cabletron Systems highly recommends using the QuickSet utility to configure the CSX500. Using the
QuickSet CD will ensure a fast and correct installation. Using other methods may not produce correct or
as efficient results as the QuickSet CD.
STS
LNK
STS
LNK
STS
LNK
STS
LNK
STS
LNK
TX
RX
TELCO
T1-1 T1-2 T1-3 T1-4
ASYNC
CONSOLE
CPU
PWR
ROUTER/SWITCH/INVERSE MUX
LAN
ENET
WAN BRANCH OFFICE CONCENTRATOR