Filter
Top Products
Chapter 7
7-1
7.1 Service Mode
7.1.1 Service Mode
0013-9799
a. How to enter the Service mode
Enter the Service mode following the procedure below.
1) Turn off the printer.
2) Turn on the printer while holding down the [Paper Source]key and [Information]key.
3) "S" will be displayed in the upper right corner of the display showing the firmware version of the printer.
4) After display of "Online", pressing the [Menu] key displays the SERVICE MODE top menu and the MESSAGE LED flashes.
* The Service mode is added to the options in the Main menu. The Service mode can be entered even in the error status(when an error message is shown on the
display)by turning the power off and then using the above key operation.
b. How to exit the Service mode
Turn off the printer.
c. Key operation in the service mode
- Selecting menus and paremeters:[ ] or [ ] key
- Going to the next lower-level menu:[ ] key
- Going to the previous higher-level menu:[ ] key
- Determining a selected menu or parameter:[OK] key
7.1.2 Map of the Service mode
0014-9306
The hierarchy of menus and parameters in the Service mode is shown below.
F-7-1
Y,PC,C,PGY,GY,MBK,PM,M,BK,R,G,B
DISPLAY
YES
NO
S/N
TYPE
LF TYPE
Test Print
TMP
SIZE LF
SIZE CR
S/N R
S/N L
LOT R
LOT L
01
20
01
20
WARING
ERROR
INK CHECK
System Setup
SERVICE MODE
PRINT INF
SYSTEM
HEAD
INK
(ADJUST)
BK
MBK
C
M
Y
PC
PM
GY
PGY
R
G
B