Filter
Top Products
4-4 Sending Faxes With the MultiPASS L6000 Chapter 4
❍ When the document has been sent successfully, the display
shows this message.
The MultiPASS automatically redials if the receiving fax does
not answer, if the line is busy, or if a transmission error occurs.
You can specify the number of times it redials using the
Automatic Retries option in the Send Fax dialog box of the
MultiPASS Desktop Manager (see page 8-4). If all redial
attempts fail, the MultiPASS beeps intermittently for a few
seconds. If this happens, check the fax number and try sending
the fax again.
If the
ALARM
light is flashing, correct the error described in the
LCD display, and then press
STOP
. You may need to open the
operator panel to remove the document from the ADF (see
page 10-3).
Automatic Dialing
You can send a document using one-touch speed dialing, coded speed
dialing, or group dialing. You must register the one-touch speed dialing
numbers, the coded speed-dialing numbers, and the group dialing
numbers using the MultiPASS Desktop Manager before you can send
documents using these automatic dialing methods. See Setting Up Your
Speed Dial Assignments on page 3-18.
❍ Place the document facedown in the ADF.
DOCUMENT READY
Load the
document.
1
TRANSMITTING OK
MP L6000—USERS MANUAL/V000/12-97