Filter
Top Products
22 Installing the Scanner
Note
• The SCSI ID is set to 2 at the factory.
• The SCSI ID is set with the Dip Switches on the back of the scanner. The
Dip Switches are on when they are down, and off when they are up.
• To change the SCSI ID, be sure to turn OFF the scanner and the computer
and refer to the following table to set the SCSI ID.
1
ON
2
Default Settings
(SCSI ID = 2)
SCSI ID
2
3
4
5
SW1
OFF
ON
OFF
ON
SW2
OFF
OFF
ON
ON
IMPORTANT
• Turn OFF the power to the computer and the scanner before connecting the
computer and setting the SCSI ID.
• The scanner has a built-in terminator that is fixed in the “ON” position. To
connect the scanner with other SCSI devices in a daisy chain configuration,
be sure to position the scanner at the end of the daisy chain, and turn off the
terminators in the other SCSI devices.
• Be careful that the IDs for other SCSI devices connected or built-in to the
computer do not duplicate the SCSI ID for the scanner.