Filter
Top Products
E
12
OPERATION
3
P
O
W
E
R
-+
WIDE TELE
NEAR FAR
MANUAL
AUTO
-
EXPOSURE
FOCUS
ZOOM
LIGHTS
BACK
LIGHT
Turn the power ON.
When the power of the RE-350 is turned ON, the POWER
indicator on the operation panel lights up.
Turn ON the power source of the other equipment to be used.
Either the power of the RE-350 or other equipment may be turned on first.
Put the document at the center of the
document table.
If no image is displayed, check to see that the lens cap has
been removed.
Press the AUTO FOCUS button to focus.
The AUTO FOCUS indicator flashes initially, then lights up
when adjustment is completed. If adjustment is unsuccessful,
the indicator goes off (see page 13).
After placing the document,press the ZOOM buttons (WIDE
button or TELE button) to adjust the image to the desired size.
Whenever the image cannot be focused properly, press the
AUTO FOCUS button.
1
2
3
4
PO
W
ER
The power of the RE-350 should be turned OFF when the unit is not used.
Disconnect the power cord if the unit will not be used for extended periods.
MEMO
• White balance will be automatically adjusted when the power
is turned ON. The AUTO WHITE BALANCE indicator flashes
initially, then lights up when adjustment is completed. If
adjustment is unsuccessful, the indicator goes off (see page
14). Focus can also be automatically compensated.
• White balance will be automatically readjusted if the
illumination lamps or backlight are turned on.
MEMO
To appropriately adjust the white balance, turn ON the power
of the RE-350 before putting the document on the table.
MEMO
When operation is completed, turn the power
OFF.
The POWER indicator goes off. The illumination lamps or
backlight will go off (if they are on). Also turn OFF the power of
other equipment.
5
After turning the power OFF, wait at least 5 seconds before
turning the power ON again. Turning the power ON too soon
may cause a malfunction.
Operation panel
NOTICE
Document table
Power switch
Operation Panel