Operation Guide DQ-746
1
MA0506-EA
• A sticker is affixed to the glass of the clock when you purchase it. Be sure to remove the sticker before using the
clock.
• Depending on the clock model, its configuration may differ somewhat from that shown in the illustration.
Current time
(Hour, minutes,
seconds)
Day of the week
Current
temperature
Date
(month - day)
PM indicator
Alarm time
Snooze on
indicator
Alarm on indicator
Alarm Off Snooze Alarm On
SNZ
ON
OFF
SET°C/°F
SET°C/°F
RESETINVALID
RESETINVALID
ILLUSTRATION
GENERAL GUIDE
11
11
1 SNOOZE/LIGHT button
• Press this button to illuminate the display for about five seconds.
• Pressing this button while the alarm is sounding stops the alarm.
22
22
2 Alarm Mode selector
SNZ: Snooze alarm on
ON: Alarm on
OFF: Alarm off
33
33
3 + / – buttons
Use these buttons to change the alarm time or the setting that is flashing on the display.
44
44
4
°C/°F button
Press this button to toggle the temperature units between Celsius and Fahrenheit.
55
55
5 SET button
Use this button when setting the current time.
66
66
6 RESET button
Press this button to reset the clock after replacing its batteries.
• Buttons marked “INVALID” have no function.
USING THE CLOCK
1. Press the SET button (5) to cycle through the setting screens as shown below.
12-hour/24-hour
Timekeeping Screen
Time Setting ScreenMonth and Day
Setting Screen
Year Setting Screen
Normal Timekeeping Screen
2. While the screen you want is displayed, use the + and – buttons
(3) to change the flashing digits.
• Holding down + or – changes the flashing digits at high speed.
• You can set the year in the range of 2000 to 2039. The day of the
week is set automatically in accordance with the date setting.
• Pressing + or – while the Time Setting Screen is on the display
causes the seconds count to be reset to 00.
• Each press of + or – while the 12-hour/24-hour Timekeeping
Screen is on the display toggles between 12-hour and 24-hour
timekeeping.
3. After making the settings you want, use the SET button (5) to display the Normal Timekeeping Screen.
• The clock automatically returns to the Normal Timekeeping Screen if you leave a setting screen on the display for
about three minutes without performing any operation.
SET°C/°F
Press
+
to
increase
the flashing
digits.
Press
–
to
decrease
the flashing
digits.