Filter
Top Products
Setup up Minimum Stock on all PLU’s
1. Turn Mode Key to PGM
2. Enter 3 – Sub Total
3. Enter 99000004 and press subtotal (range programming for PLU’s)
4. Enter 1466 press subtotal
5. Enter plu start range no. and press ca/amt tend (press ca/amt tend before entering
a number to skip this step)
6. Enter plu end range no. and press ca/amt tend (press ca/amt tend before entering a
number to skip this step, if you were to skip both steps this will automatically
select all PLU’s in the system)
7. Enter 1000 – Cash – Sub Total
Adding stock to PLU Numbers
1. Turn mode switch to X Mode
2. Enter 2 and press subtotal
3. Enter PLU No and then press PLU Key,
4. Enter stock amount for example enter 100 now press CA/AMT
5. Press Subtotal
Subtract stock to PLU Numbers
1. Turn mode switch to X Mode
2. Enter 2 and press subtotal
3. Enter PLU No and then press PLU Key
4. Press RF (Refund)
5. Enter stock amount for example enter 100 now press CA/AMT
6. Press Subtotal
Input New stock to PLU Numbers
1. Turn mode switch to X Mode
2. Enter 8 and press subtotal
3. Enter PLU No and then press PLU Key,
4. Enter stock amount for example enter 100 now press CA/AMT
5. Press Subtotal
Take a Stock Report
1. Turn mode switch to x mode
2. Enter 64 & press Cash
3. Turn mode Switch to Reg Mode
This will give a stock on hand report