Filter
Top Products
75
E
Advanced Operations
Printing slip
To perform batch printing on the slip printer, you must fi rst use the memory allocation operation (see program 5
mode in the dealer’s manual) to reserve slip buffer memory. The capacity of the slip buffer memory is determined
by the number of units of slip buffer memory reserved by the memory allocation operation.
The register can be programmed to check the status of the registration buffer memory whenever slip batch printing
is performed, and sound an alarm when the buffer memory is almost full. The alarm sounds when there are 12 lines
or less remaining, and once it starts to sound, the only operation you can perform is the cancel operation or opera-
tions using one of the following keys.
• <CA/AMT TEND> (cash / amount tendered key) operation
• <CH> (charge key) operation
• <CHK/TEND> (check tendered key) operation
• <DEPOSIT> (deposit key) operation
• <NEW BALANCE> (new balance key) operation
• <SUBTOTAL> (subtotal key) operation
You must perform one of above operations when the registration buffer alarm sounds. Any other operations results
in an error.
Printing slips
The cash register can be connected to the optional SP-1300 slip printer, which features an automatic feed function
and automatic back feed function.
• Automatic feed function
This function makes it possible to program the number of line feeds that should be inserted from the normal print
start position before starting slip printing of a new slip. Even if line feeds are programmed for this function, they
are not inserted for validation printing, check endorsement printing, and check printing performed using the slip
printer. Note also that line feeds are not inserted automatically at the beginning of a second slip when the transac-
tion requires printing that extends from one slip to another.
• Automatic back feed function
This function performs automatic back feed following slip printing, validation printing, and endorsement printing
on the slip printer. The slip paper is released once the back feed operation is complete.
• Manual feed function
<SLIP FEED/RELEASE> ( slip feed / release key: assigned to the register’s keyboard using the program 4 mode)
can be used for manual feed of the slip paper. You perform manual feed by inputting a value for the number of
lines (up to two digits in the range of 1 to 99) and then press <SLIP FEED/RELEASE>.
• Manual back feed function
<SLIP BACK FEED/RELEASE> ( slip back feed / release key: assigned to the register’s keyboard using the
program 4 mode) can be used for manual back feed of the slip paper. Manual back feed can be performed by
inputting a value for the number of lines (up to two digits in the range of 1 to 99) and then press <SLIP BACK
FEED/RELEASE>.
You can print slips using automatic or manual batch printing. The slip print operation can be performed in REG1,
REG2, and RF modes only.
Finalizing a registration without inserting a slip paper into the slip printer when the register is programmed as
“ slip paper insertion into slip printer compulsory before fi nalizing registration” produces an error.