Filter
Top Products
94
E
This section describes what to do when you have problems with operation.
When an error occurs
Errors are indicated by an error tone. When this happens, you can usually find out what the problem is as
shown below.
Troubleshooting
Error code
Meaning Action
(Message)
Mode switch position changed before finaliza-
tion.
The signed on clerk differs from the clerk
performed the check tracking operation.
Registration without entering a clerk number.
Platen arm of the printer is opened.
Registration is made while the cash drawer
is opened.
Journal paper end
Receipt paper end
Attempt made to register an item without
inputting a table number.
Registration without inputting number of
customers.
Transaction cancel buffer full.
Finalization of a transaction attempted without
confirming the subtotal.
Finalize operation attempted without entering
amount tender.
Change amount exceeds preset limit.
Read/reset operation without declaring cash in
drawer. This error appears only when this
function is activated.
Attempt made to finalize a transaction without
issuing a guest receipt.
Check tracking memory full
Attempt made to use the new check key to
open a new check using a number that is
already used for an existing check in check
tracking memory.
Attempt made to use the old check key to
reopen a new check using a number that is not
used for an existing check in check tracking
memory.
Return the mode switch to its original setting
and finalize the operation.
Input correct check number or assign the proper
clerk number.
Enter a clerk number.
Close the platen arm.
Close the cash drawer.
Replace the new paper roll.
Replace the new paper roll.
Input a table number.
Input number of customers.
Finalize the transaction.
Press the s key.
Enter the amount tendered.
Input amount tendered again.
Perform money declaration.
Issue a guest receipt.
Finalize and close the check number currently
used.
Finalize and close the check that is currently
under used or use a different check number.
Use the correct check number (if you want to
reopen a check that already exists in the check
tracking memory) or use the new check key to
open a new check.
E01
(ERR-MODE)
E03
(ERR-CLK)
E08
(SIGN-ON)
E10
(PRNT-LID)
E11
(DRW-OPEN)
E12
(JPAP-END)
E14
(RPAP-END)
E17
(CHECK-No)
E19
(COVERS)
E27
(BUF-FULL)
E31
(PRESS-ST)
E33
(TEND-AMT)
E35
(CNG-OVER)
E38
(DECL-AMT)
E40
(PRNT-RCT)
E50
(MEM-FULL)
E51
(OCCUPIED)
E53
(NOT-OPEN)