Filter
Top Products
7
FCC WARNING:
Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to operate
the equipment.
WARNING: This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
GUIDELINES LAID DOWN BY FCC RULES FOR USE OF THE UNIT IN THE U.S.A.
(Not applicable to other areas)
Precautions for Use
Read the following items thoroughly and use the device accordingly. Casio bears no responsibility
whatsoever for damage or malfunctions that occur due to handling the device contrary to the following
instructions. Also, please note that the cost of any repairs will be charged even if still under warranty for free
repairs.
Installation Location
Do not position the device in places that are very hot or dusty or where it will come in contact with
oil, smoke or water. Never store or leave the device in the following kinds of places. Doing so may
cause damage to the device such as lost memory and/or warping of the case.
● Low temperatures of 5°C or colder
● Inside vehicles in the summer
● Near cooling/heating equipment
● Places subject to direct sunlight
● Places that reach temperatures of 40°C or higher
Avoid using the device in the following places.
● Outdoors
● Near equipment that gets hot, such as stoves and electric heaters
● Places likely to be subject to moisture and/or steam
● Places with drastic changes in temperature and/or humidity
● Places that produce corrosive gases and/or salt
● Places that generate rubbish or dust
● Places subject to vibration
● Places where static electricity is likely to occur
Other
● Prepare an AC power line separate from any with noise, such as from a motor, ice maker,
microwave, etc.
● Do not touch the power switch when your hands are wet. Doing so may result in a shock.
● Immediately wipe off any water that gets on the device with a dry cloth.
● Do not use any chemicals, such as thinner, alcohol, benzene, etc., for cleaning. When the device
gets dirty, dampen a soft, dry cloth with a weak detergent, wring it out as much as possible and wipe
it off.