Filter
Top Products
13-61
Cisco ONS 15454 Reference Manual, R7.0
78-17191-01
Chapter 13 Management Network Connectivity
13.7 13.7.10 Provisioning OSI in CTC
13.7.10 Provisioning OSI in CTC
Table 13-18 shows the OSI actions that are performed from the node view Provisioning tab. Refer to the
Cisco ONS 15454 Procedure Guide for OSI procedures and tasks.
Table 13-19 shows the OSI actions that are performed from the node view Maintenance tab.
Table 13-18 OSI Actions from the CTC Provisioning Tab
Tab Actions
OSI > Main Setup
• View and edit Primary Area Address.
• Change OSI routing mode.
• Change LSP buffers.
OSI > TARP > Config Configure the TARP parameters:
• PDU L1/L2 propagation and origination.
• TARP data cache and loop detection buffer.
• LAN storm suppression.
• Type 4 PDU on startup.
• TARP timers: LDB, T1, T2, T3, T4.
OSI > TARP > Static TDC Add and delete static TARP data cache entries.
OSI > TARP > MAT Add and delete static manual area table entries.
OSI > Routers > Setup
• Enable and disable routers.
• Add, delete, and edit manual area addresses.
OSI > Routers > Subnets Edit SDCC, LDCC, and LAN subnets that are provisioned for OSI.
OSI > Tunnels Add, delete, and edit Cisco and IP-over-CLNS tunnels.
Comm Channels > SDCC
• Add OSI configuration to an SDCC.
• Choose the data link layer protocol, PPP or LAP-D.
Comm Channels > LDCC
• Add OSI configuration to an SDCC.
Table 13-19 OSI Actions from the CTC Maintenance Tab
Tab Actions
OSI > ISIS RIB View the IS-IS routing table.
OSI > ESIS RIB View ESs that are attached to ISs.
OSI > TDC
• View the TARP data cache and identify static and dynamic entries.
• Perform TID to NSAP resolutions.
• Flush the TDC.