Filter
Top Products
1-36
Cisco ONS 15454 Reference Manual, R7.0
78-17191-01
Chapter 1 Shelf and Backplane Hardware
1.5 1.5.9 UBIC-H EIA
If you are installing UBIC-H EIAs after the shelf assembly is installed, plug the UBIC-H EIA into the
backplane. The UBIC-H backplane must replace the standard sheet metal cover to provide access to the
cable connectors. The UBIC-H sheet metal covers use the same screw holes as the standard sheet metal
covers, but they have 12 additional holes for panhead screws and three holes for jack screws so you can
screw down the cover and the board using standoffs on the UBIC-H board.
When installed with the standard door and cabling on the backplane, the ONS 15454 shelf measures
approximately 14.5 inches deep when fully populated with backplane cables, and 15.0 inches deep with
the rear cover installed. When installed with the deep door and cabling on the backplane, the ONS 15454
shelf measures approximately 16.5 inches deep when fully populated with backplane cables, and 17.0
inches deep with the rear cover installed.
The UBIC-H EIA supports the following cards:
• DS1-14, DS1N-14
• DS3-12, DS3N-12
• DS3-12E, DS3N-12E
• EC1-12
• DS3XM-6
• DS3XM-12
• DS3/EC1-48
• DS1/E1-56
Table 1-13 J-Labelling Port Assignments for a Shelf Configured with High-Density Electrical
Cards (A Side)
Slot Port Type
TX J4 J3 J2 J1 J5 J6 J7 J8
RX J12 J11 J10 J9 J13 J14 J15 J16
Ports Ports Ports Ports Ports Ports Ports Ports
1 DS-1 1–14 15–28 29–42 43–56 — — — —
DS-3 1–12 13–24 25–36 37–48 — — — —
2 DS-1 — — — — 1–14 15–28 29–42 43–56
DS-3 — — — — 1–12 13–24 25–36 37–48
Table 1-14 J-Labelling Port Assignments for a Shelf Configured with High-Density Electrical
Cards (B Side)
Slot Port Type
TX J20 J19 J18 J17 J21 J22 J23 24
RX J28 J27 J26 J25 J29 J30 J31 J32
Ports Ports Ports Ports Ports Ports Ports Ports
17 DS-1 1–14 15–28 29–42 43–56 — — — —
DS-3 1–12 13–24 25–36 37–48 — — — —
16DS-1 ————1–1415–2829–4243–56
DS-3 ————1–1213–2425–3637–48