Filter
Top Products
22
Installing the Cisco Content Engine 510 and 565
78-14731-02
Accessing the ACNS Software on the Content Engine
Accessing the ACNS Software on the Content Engine
The Content Engine uses the Cisco Application and Content Networking System (ACNS) software for
configuration and deployment of an Application and Content Network (ACN). The ACNS software
includes both a graphical user interface, accessible through a web browser, and a command-line interface
(CLI), either of which can be used to configure the software. For more information about accessing and
configuring the ACNS software, refer to the Cisco ACNS Software Deployment and Configuration Guide
that is appropriate for the version of ACNS software running on your Content Engine.
To use the ACNS software CLI, you must connect to the Content Engine either through a Telnet session
from a PC, or by connecting a PC or terminal to the Content Engine console port.
Connecting a PC to the Content Engine
To access the ACNS software on the Content Engine through the console port on the Content Engine,
you must connect the Content Engine to a terminal or PC. The console cable and adapter required for
this connection are included with the Content Engine.
To connect to the Content Engine using a PC, the PC must have some type of terminal emulation
software installed. The terminal emulation software should be configured with the following parameters:
• 9600 baud
• 8 data bits
• No parity bits
• 1 stop bit
Table 4 Fibre Channel Card LEDs
LED State Meaning
Green
Amber
On
On
Power is on.
Green
Amber
On
Off
Fibre Channel is on line.
Green
Amber
Off
On
Signal acquired (the Fibre Channel card firmware is
performing or waiting to perform Fibre Channel
loop initialization).
Green
Amber
Off
Flashing
Loss of synchronization.
Green
Amber
Flashing
Flashing
Firmware error.