Filter
Top Products
Chapter 2 Configuring User Profiles and CSS Parameters
Configuring Host Name
2-26
Cisco Content Services Switch Basic Configuration Guide
78-11424-03
Configuring Host Name
Use the host command to manage entries in the Host table. The Host table is the
static mapping of mnemonic host names to IP address, analogous to the ARP
table. The syntax for this global configuration mode command is:
host host_name ip_address
• host_name - The name of the host. Enter an unquoted text string with no
spaces and a length of 1 to 16 characters.
• ip_address - The address associated with the host name. Enter the IP address
in dotted-decimal notation (for example, 192.168.11.1).
For example, enter:
(config)# host CSS11150-LML 192.168.3.6
Note To add a host to the Host table, the host name must not already exist.
To change a current host address, remove it and then add it again.
To remove an existing host from the Host table, enter:
(config)# no host CSS11150-LML
To display a list of host names, enter:
(config)# show running-config global
Configuring Idle Timeout
To globally set the total amount of time all sessions can be active before the CSS
terminates a console or Telnet session, use the idle timeout command. Enter a
timeout value between 0 and 65535 minutes. The default value is enabled for
5 minutes.
Note To override the idle timeout value for a specific session, configure
the terminal timeout command. Terminal commands are
user-specific; that is, they apply uniquely for each CSS user.