Filter
Top Products
8 Cisco ISA500 Series Integrated Security Appliances Quick Start Guide
Rack Mounting
You can mount the security appliance in any standard size, 19-inch (about
48 cm) wide rack. The security appliance requires 1 rack unit (RU) of
space, which is 1.75 inches (44.45 mm) high. The rack-mounting kit is
included with the unit.
CAUTION Do not overload the power outlet or circuit when installing
multiple devices in a rack.
STEP 1 Place one of the supplied silicon rubber spacers on the side of the
security appliance so that the four holes align to the screw holes.
Place the rack mount bracket next to the silicon rubber spacer and
install the M3 screws.
STEP 2 Install the security appliance into a standard rack as shown below.
Place the washers on the brackets so that the holes align to the
screw holes and then install the M5 screws.
Connecting the Cisco ISA500 Series
Integrated Security Appliances
STEP 1 If you are installing the ISA550W or ISA570W, screw each antenna
onto a threaded connector on the back panel. Orient each antenna
to point upward.
STEP 2 Connect the security appliance to power using the supplied
power cord and adapter. Make sure that the power switch is
turned off.
281985
Step 1
Step 2
4