Filter
Top Products
6-5
Multiprocessor WAN Application Module User Guide
OL-4858-07
Chapter 6 Command Reference
Command Details
session slot
To establish a command session to a processor on an MWAM, use the session slot command in
privileged EXEC mode.
session slot slot_number processor processor_number
Syntax Description
Defaults There are no default behavior or values.
Command Modes EXEC mode.
Command History
Usage Guidelines When you session into processor 1, you must enter the user name (root) and password (cisco).
Examples The following example illustrates the session slot command for processor 2 on the MWAM in slot 9:
Sup-7606#session slot 9 processor 2
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.92 ... Open
proc2-9>
Press RETURN to get started!
proc2-9>
The following example illustrates the session slot command for processor 1 on the MWAM in slot 9:
Sup-7606#session slot 9 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.91 ... Open
SVCMWAM Image version 2.1(0.1b)
slot_number Specifies the slot that the MWAM is plugged into.
processor
processor_number
Specifies the MWAM processor (1-6) to connect to.
Note Only MWAM processors 2-6 contain application images; MWAM
processor 1 provides control commands for MWAM processors and
complexes.
Release Modification
12.2(9)ZA This command was introduced.