Filter
Top Products
10
Versatile Interface Processor (VIP6-80) Installation and Configuration Guide
OL-5078-01
Traffic Management
The VIP6-80 supports the following:
• Simple Network Management Protocol (SNMP) agent V1 (RFCs 1155–1157)
• Management Information Base (MIB) II (RFC 1213)
Installation Prerequisites
This section provides installation prerequisites to ensure a successful VIP6-80 installation, and includes
the following sections:
• Software Requirements, page 10
• Hardware Requirements, page 10
• Microcode Requirements, page 11
• Tools and Parts Required, page 11
• Agency Approvals, page 11
• Safety Guidelines, page 11
Software Requirements
The minimum Cisco IOS Release requirements for VIP6-80 are listed in Table 6. For configuration
information and support, refer to the modular configuration and modular command reference
publications in the Cisco IOS software configuration documentation set that corresponds to the software
release installed on your Cisco hardware.
Note You can access Cisco IOS software configuration and hardware installation and maintenance
documentation on the World Wide Web at http://www.cisco.com. Translated documentation is available
at the following URL: http://www.cisco.com/public/countries_languages.shtml.
Hardware Requirements
The VIP6-80 is a single motherboard. It operates with the following:
• Cisco 7505, Cisco 7507, Cisco 7507-MX, Cisco 7513, Cisco 7513-MX, and the Cisco 7576 routers
with the Route Switch Processor (RSP1, RSP2, RSP4, RSP4+, RSP8, or RSP16); the RSP should
have at least 64 MB of DRAM
Table 6 VIP6-80 Minimum Software Release Requirements
VIP Release Minimum Cisco IOS Supported Releases
VIP6-80 Cisco IOS Release 12.0(22)S or later release of Cisco IOS Release 12.0 S
Cisco IOS Release 12.1(12)E or later release of Cisco IOS Release 12.1 E
Cisco IOS Release 12.2(12)T or later release of Cisco IOS Release 12.2 T