Cisco Systems (VIP6-80) Network Card User Manual


 
34
Versatile Interface Processor (VIP6-80) Installation and Configuration Guide
OL-5078-01
Removing SDRAM DIMMs
Use the following procedure to remove the existing DIMMs:
Step 1 Turn off the system power and remove the VIP6-80 from the system. (Follow the steps in the “Removing
a VIP6-80” section on page 18.)
Step 2 Place the VIP6-80 on an antistatic mat or pad and ensure that you are wearing an antistatic device, such
as a wrist strap.
Step 3 Position the VIP6-80 so that the handles are away from you and the bus connectors are toward
you—opposite of the position shown in Figure 2.
Step 4 Locate the DIMM and position the VIP6-80 so that you are facing the DIMM module you want to
remove.
Step 5 Open the DIMM socket tabs on the DIMM to release the DIMM from the socket. (See Figure 9.) The
DIMM is under tension in the socket; therefore, the DIMM might be released from the socket with some
force.
Figure 9 Opening the DIMM Socket Tabs
Step 6
With the DIMM socket tabs open, grasp the ends of the DIMM between your thumbs and forefingers and
pull the DIMM completely out of the socket. (See Figure 10.)
Figure 10 Removing the DIMM
Step 7
Place a removed DIMM on an antistatic mat, and store it in an antistatic container to protect it from ESD
damage.
SDRAM DIMM
13339
Pull the tabs away with
your thumbs, bracing your
forefingers against the
DIMM socket sides
13341
Polarization notch Metal fingers