Filter
Top Products
CBM-920 User’s Manual
36 CITIZEN
(5) Initial set (DC1) command
By inputting DC1 (11H), each condition specified after power is ON is canceled and printer goes to initial
condition same as the condition right after power is ON.
But, the data in input buffer is not changed.
(6) Continuous line feed specifying (ESC + "B" + n)
By inputting ESC (1BH) + "B" (42H) + n code, printer performs continuous line feeding at n dot lines.
But, n is to be within 4 ≤ n ≤ 255 and must be even number. In case odd number is specified for n, this is to
be concerned as even data of "n - 1".
And in case that n is specified at the out of available range, this command is automatically ignored.
When inputting this command, in case there is some data in the input buffer, printer prints the data. But the
printed line (10 dots line) is included in the volume of line feed n Therefore in case n is 4 ≤ n ≤ 9line
spacing may go to "0".
(7) International character specifying command (ESC + "R" + n )
By inputting ESC (1BH) + "R" (52H) + n code, the character after this command is set at the characters
table of specified country.
The value of n and setting of each countries
n Country n Country
0 U.S.A. 5 Sweden
1France 6Italy
2Germany 7Spain
3 U.K. 8 Japan
4Denmark
Remarks: In case the value of n is out of the above range, Country is set automatically at U.S.A.
When power is ON, initial setting varies depending on Dip Switch setting.