Filter
Top Products
CITIZEN 35
(8) Specifying the Bit Image Mode (ESC * m n1 n2 D1 - Dn)
Code : [1B]h + [2A]h + m + n1 + n2 + Dn
* {m= bit image mode (See the table below.)}
{0 ≤ n1 ≤ FF}
{0 ≤ n2 ≤ 02} Data is described in Hex code.
According to the number of dots specified in n1, n2, specify the bit image of mode n.
l The no. of dots printed is divided by 256, whose quotient is taken as n2 and residualas n1.
l The total no. of dots printed in the bit image is equal to n1 + (256 x n2).
l When bit image data have been input in excess of dot position of one line (448 dots) , the excess
data are discarded.
l d is bit image data, the bits subject to printing are taken as "1" and those not as "0".
l The bit image modes specified by m are shown as follows:
VERTICAL DIRECTION HORIZONTAL DIRECTION
m(Hex) MODE NO. OF DOTS DOT DENSITY DOT DENSITY MAX. NO OF DOTS
0 8-dot signle density 8 67 DPI 101 DPI 224 (208)
1 8-dot double density 8 67 DPI 203 DPI 448 (416)
32 24-dot single density 24 203 DPI 101 DPI 224 (208)
33 24-dot double density 24 203 DPI 203 DPI 448 (416)
l When the values set in m (bit image mode) are out of the above range, the data following after n1 is
processed as normal printing data.
l After completion of bit image printing, printer returns to normal data processing mode.
(9) Specifying/ Canceling Underline (ESC - n)
Code: [1B]h + [2D]h + n
* {0 ≤ n ≤ 02} data is described in Hex code.
Specifying/canceling an underline.
l An underline is attached to the full character width. It is, however, not attached to the part
having been skipped by horizontal tab command.
l An underline is not attached to a 90 ° - right-turned characters.
l Types of underlines by n value are shown below:
n (Hex) Type
0 Canceling an underline.
1 Specifying an underline for 1-dot width.
2 Specifying an underline for 2-dot width.