Filter
Top Products
31
4.After removing the rewinder shaft,
install the copy roll paper and pull the
end of the roll paper straight towards
you for about 30cm as shown in the
figure.
Hold the center of the roll paper to pull it
as straight as possible so that one of the
sides of the paper does not slacken.
5.Maintaining light tension in the copy
roll paper, firmly close the platen unit
until you hear a click.
6.
Set one side of the copy roll paper
(copy side) on the rewinder shaft as
shown in the figure, and tightly wind
it about 2 rotations in the direction
shown by the arrow.
Check to make sure that the copy roll
paper rotates with the rewinder shaft.
2P or 3P copy roll paper
Rewinder shaft
About 30cm
Roll paper that is
gently pulled taut.
Platen unit
Be careful of the paper cut bar.
Copy roll paper
(copy side)
Rewinder shaft
Wind it about twice
Protrudes
about 5cm
Preparing the Printer
Be very careful not to let
your hands touch the blade
on the paper cutter bar.
Caution