Filter
Top Products
Chapter 4: Using the Printer 35
A760-D100 10/04 189-9200303 Rev. D A760 Two-Color Thermal/Impact Hybrid Printer: User Guide
Enable or disable receipt test mode
The receipt test mode verifies proper receipt printing. Receipt test is enabled and disabled by
selecting the “Diagnostic Modes” sub-menu of the configuration menu. See “Configuring the
printer”, page 32 for instructions on how to enter the configuration menu.
To run the Receipt test mode:
1 Enable the receipt test mode in the configuration
menu.
2 Exit the configuration menu.
3 Push the paper feed button. The receipt station
prints two code pages and cuts the receipt.
4 To repeat this test, push the paper feed button again.
To exit the receipt test mode:
1 Enter the configuration menu again. (See
“Configuring the printer”, page 32.)
2 Disable the receipt test mode.
3 Exit the configuration menu.
The printer is on-line and can again communicate
normally with the host computer.
Enable or disable slip test mode
The slip test mode verifies proper printing on a slip. Slip test is enabled or disabled by
selecting the “Diagnostic Modes” sub-menu of the configuration menu. See “Configuring the
printer”, page 32 for instructions on how to enter the configuration menu.
To run the slip test mode:
1 Enable the slip test mode in the configuration menu.
2 Exit the configuration menu.
3 Insert a slip into the slip station.
4 Push the paper feed button. Two code pages will be
printed.
5 To repeat this test, preform steps 3 and 4 again.
To exit the slip test mode:
1 Enter the configuration menu again. (See
“Configuring the printer”, page 32.)
2 Disable the slip test mode.
3 Exit the configuration menu.
The printer is on-line and can again communicate
normally with the host computer.
Enable or disable MICR test mode
MICR test mode tests the MICR operation. In this mode the MICR reads the characters on a
check, but instead of transmitting the values to the software it prints them out.
MICR test is enabled or disabled by selecting the “Diagnostic Modes” sub-menu of the
configuration menu. See “Configuring the printer”, page 32 for instructions on how to enter
the configuration menu.
To run the MICR test mode:
1 Enable the MICR test mode through the
configuration menu, see page 32. Then exit the
configuration menu.
2 Insert a check into the slip station. (See “Verifying
and validating checks,” page 28.)
3 Once a check is detected by the printer, the platen
closes and the characters are read by the MICR
check reader. The decoded data is printed as
characters on receipt paper. The platen is then
opened, and the test
is re-started.
4 The printed characters should match the characters
on the check. If the MICR check reader misreads a
character, a question mark “?” is printed. If no
characters can be read, “NO MICR CHARACTERS”
is printed.
To exit the MICR test mode:
1 Enter the configuration menu again.
2 Disable the MICR test mode.
3 Exit the configuration menu.
The printer returns to normal mode and can again
communicate with the host computer.